• 您好,歡迎光臨萊州聚峰機械有限公司網站! 主營自動攪拌車,攪拌一體車,自動上料攪拌車等各種規格的產品。

    自動上料攪拌車生產廠家

    點擊撥打服務熱線:4008791999

    您的位置:首頁 - 新聞中心 > 行業資訊 >

    防止攪拌車混凝土沾罐快裝快卸的方式

    發布時間:2022-10-28 來源:http://www.sarahpalintshirt.com/ 瀏覽量:

    概述:自動上料攪拌車為建設提供了很大的便利,但是由于混凝土材料存在的特殊性,方便的同時卻又時常有粘罐的現象,本文就結合自動上料攪拌車使用
    自動上料攪拌車為建設提供了很大的便利,但是由于混凝土材料存在的特殊性,方便的同時卻又時常有粘罐的現象,本文就結合自動上料攪拌車使用過程中出現的混凝土粘罐現象,對其產生的原因提出了建議和改進措施。
    The automatic feeding mixer provides great convenience for construction, but because of the particularity of concrete materials, it is convenient and often has the phenomenon of tank sticking. This paper puts forward suggestions and improvement measures on the causes of the phenomenon of tank sticking in combination with the phenomenon of concrete during the use of the automatic feeding mixer.
    一、隨車帶上一些備用的減水劑
    1、 Take some spare water reducing agent with the vehicle
    減水劑是一種在維持混凝土坍落度不變的條件下,能減少拌合用水量的混凝土外加劑,隨車攜帶,能對混凝土進行很好的調節。不過在加入減水劑的時候,一定要記得有商砼站化驗室的人在場,否則混凝土質量強度不夠,后果會很嚴重。
    Water reducing agent is a kind of concrete admixture that can reduce the mixing water consumption under the condition of maintaining the constant concrete slump. It is carried with the vehicle and can adjust the concrete well. However, when adding water reducing agent, be sure to remember that there are people in the laboratory of the commercial concrete station, otherwise the concrete quality and strength are not enough, and the consequences will be very serious.
    二、回站檢查儲水罐內的水量
    2、 Return to the station to check the water volume in the water storage tank
    每次出車卸完料回到站內的時候,檢查儲水罐內的水量,確保讓水罐中的水隨時處于滿罐的狀態,以備不時之需。自動上料攪拌車
    Every time when the vehicle is unloaded and returns to the station, the water volume in the water storage tank shall be checked to ensure that the water in the tank is always full for emergency. Automatic feeding mixer
    自動上料攪拌車
    三、離站前檢查混凝土質量
    3、 Check the concrete quality before leaving the station
    可能會因為原料的不同,每一車混凝土質量都會有變化。在裝好混凝土離場時,一定要檢查罐內混凝土的塌落度以及和易度,小心混凝土的提前凝結和混凝土離析沉淀。
    The quality of each truck of concrete may change due to different raw materials. When the concrete is loaded and leaving the site, the slump and workability of the concrete in the tank must be checked, and care must be taken for the early setting and segregation of the concrete.
    四、盡量減少車輛行駛的時間
    4、 Minimize the time the vehicle travels
    混凝土運輸距離一般在半徑20公里范圍以內,出車之前規劃好行車路線以及車輛性能情況,盡量減少車輛在路上的行駛時間。自動上料攪拌車
    The concrete transportation distance is generally within the radius of 20km. Before driving, the driving route and vehicle performance shall be planned to minimize the driving time of vehicles on the road. Automatic feeding mixer
    五、特殊情況為了減少損失先卸料
    5、 Under special circumstances, discharge materials first to reduce losses
    如果遇人為或不可抗因素,導致長時間無法卸料的情況,應隨時查看罐內混凝土情況,一旦發現混凝土開始凝結。應立刻進行卸料,以防整個罐體凝罐報廢。
    If it is impossible to unload materials for a long time due to man-made or irresistible factors, the concrete in the tank shall be checked at any time. Once it is found that the concrete starts to set. Unloading shall be carried out immediately to prevent the whole tank from being scrapped.
    混凝土在攪拌罐及葉片上凝結的粘罐現象在自動上料攪拌車長期工作中經常會產生,若是不及時進行清理,不但因罐體容量不足,使車輛負荷過大,引起液壓泵和液壓馬達故障,更容易造成裝載的混凝土離析。以上http://www.sarahpalintshirt.com的內容希望能夠給您幫助!
    The phenomenon of concrete caking on the mixing tank and blades often occurs during the long-term operation of the automatic feeding mixer. If it is not cleaned in time, not only the insufficient tank capacity will lead to excessive vehicle load, which will lead to the failure of the hydraulic pump and motor, but also the segregation of the loaded concrete. above http://www.sarahpalintshirt.com I hope we can help you!

    截屏,微信識別二維碼

    又黄又爽又色两性午夜刺激视频_又爽又黄A片免费观看_又爽又黄又刺激网站在线观看免费_主页